Broan micromate replacement switch install#
Broan micromate replacement switch manual#

If it is not possible to connect them on the same circuit, try to maintain various installations on one electrical phase. To obtain maximum link performance, connect multiple installations to one electrical circuit. Interconnection pathways are referred to as links. Multiple installations connect through the house's electrical power circuits to create an indoor air quality network. Multiple installations will offer distributed ventilation in the entire house.

Broan micromate replacement switch install#

However, it is advisable to install several of them for homes with more than one bathroom. One Broan SmartSense system is strong enough to offer the ventilation rates needed in big houses. LED is off once the pressed paddle associated with the Feature is off and on when the Feature associated with the pressed paddle is on. Program/Feature Selection Mode: LED turns on and off with a slow blink as the system is in Feature Selection or Program mode. It turns on for a short period every second when the fan is on automatic ventilation. The LED is turned on by pressing ON PADDLE.

Broan micromate replacement switch manual#

RunMode: LED is on once the fan is on manual ventilation and off when the fan is off. LED operates differently in run and Program/Feature Selection modes. Read and understand all the instructions before starting the installation process.This unit should not be connected as a load on a light dimmer or a fan speed control.When drilling or cutting into a ceiling or wall, be careful to avoid damaging electrical wiring and other hidden components.Enough air is required for proper combustion and exhausting gasses via the fuel-burning chimney to avoid back-drafting.The technician should do electrical wiring and installation wiring as per all applicable codes and standards.

If the service panel cannot be locked, put a warning notice on it.

Before you clean or service the device, turn off the power at the service panel and lock it to avoid being turned on accidentally.

In case of any questions, get in touch with the manufacturer through the telephone number or address written in the warranty.

Use this device as prescribed by the manufacturer.

To minimize the risk of fire, electric shock, or injury to persons, observe the following: These are discussed in detail in the later section of this guide. Monitor the fan on time and set automatic ventilation as required to obtain maximum energy consumption.Īdditional features switched off at the factory include Delayed-off, Vacation, Automatic-Off, and Disabled modes. Power outage does not interfere with the settings as they are stored in non-volatile memory. The ventilation level is set during installation based on the number of bedrooms and home square footage. Other ventilation requirements are taken care of if the system is correctly installed. Inspect drive parts after disconnecting power and replace any worn or broken components.The Broan SmartSense system offers the required ventilation for indoor air quality.

Ram doesn't move while the motor is running-The power screw or power nut that moves the ram may be broken or loose.

Unit runs continuously with the ram in the lower position-This can be caused by issues with the drive gear or the drive chain.

Unit runs continuously with the ram in upper position-The upper-limit switch is likely faulty and may need to be replaced.

Door doesn't open easily-Check to make sure that the drawer slides along the rails without any obstructions.Replace the start switch if it sticks in the start position. Won't stop running-The start switch may be stuck in the start position.If it's excessively dirty, replace it.Ĭommon problems with Broan trash compactors If your Broan range hood isn't venting properly, check the charcoal filter.The motor shaft bearings may need replacement. If the exhaust fan motor is humming in your Broan range hood, inspect it carefully.If that's not the problem, it may be the motor. If your Broan bathroom fan isn't working, try turning the fan blade by hand to check for damage.If your heater isn't reaching the desired temperature, you may need a new thermostat or heating element.If your Broan heater doesn't blow air, it may need a new motor.Getting to the bottom of a Broan appliance malfunctionĬertain malfunctions are more common than others.